最新的Riverbed RCPE Certified Professional WAN Optimization - 830-01免費考試真題

A. Raise alarm when asymmetric routes are detected

B. Raise alarm when network interface link errors are detected

C. Raise alarm when network interface duplex errors are detected

D. Raise alarm when the number of optimized connections exceeds user specified limit

E. Raise alarm if a software version mismatch is detected in the network

A. To make sure cluster SteelHeads remain connected to the same Interceptor.

B. To ensure asymmetrically routed connections are optimized.

C. To maximize the benefits of SDR by maintaining SteelHead peering relationships.

D. To keep similarly sized SteelHead models peering with each other.

E. To ensure load is distributed evenly throughout the cluster.

A. A separate connection between the Primary IP addresses of the client and server Steelhead appliances

B. No such construct exists

C. A virtual connection contained within one of the inner-connections which corresponds to a client-server connection

D. A separate inner-connection between two Steelhead appliances not directly related to any one of the user inner connections

A. Create new peering rule(s) on your Steelhead appliances

B. Reload only the data center Steelhead appliance

C. Reload all of your Steelhead appliances

D. Create IPSec tunnels between all of your Steelhead appliances

E. Create new in-path rule(s) on your Steelhead appliance

A. No Load Balancing rules are needed for the administrator's policy

B. A Redirect Load Balancing rule containing Steelhead-1 and Steelhead-2

C. Two Redirect Load Balancing rules; first rule for Steelhead-1 and second rule for Steelhead-2

D. Two Redirect Load Balancing rules; first for both Steelhead-1 and Steelhead-2, second one for Steelhead-2

A. verify interceptor deployment

B. debug validate deployment

C. config checker

D. service verify

A. SSL advanced mode

B. Passive key derivation

C. Early start/late finish

D. SSL proxy support and SNI (Server name indication)

A. Remove fixed-target rule from the server-side Steelhead appliance

B. Fixed-target rule is needed on the client-side Steelhead appliance

C. Add Redirect-IN on the WAN at the HQ

D. Remove Redirect-IN from the LAN at the Branch Office

E. Change the WCCP to use Redirect Out instead of Redirect In

A. Need to issue the command "in-path accept connections" on Steelhead-D

B. Steelhead-B and Steelhead-C are missing the "in-path neighbor continue-intercept" command

C. Steelhead-D is missing the "in-path neighbor allow-failure" command

D. Simplified routing is not enabled

E. The load balancing algorithm on the router is broken