最新的Cisco Implementing Cisco Data Center Unified Fabric (DCUFI) - 642-997免費考試真題

A. The Overlay1 IP address should be a multicast IP address.

B. The Site 2 OTV edge device has gone down.

C. The MAC address cannot be discovered on two separate port channel interfaces.

D. The MAC address that ends in 020a moved to the local site 23 hours ago.

A. aaa session-id common

B. aaa new-model

C. radius server radius-server-name

D. radius-server vsa send authentication

A. disable LAN traffic on the interface

B. permit all VSANs on the interface

C. configure PortFast on the access port

D. permit all VLANs on the interface

A. 8 MB

B. 1024 MB

C. 5 MB

D. 4 MB

E. 1 GB

A. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4099

B. Every FabricPath must have a manually configured switch-id for it to form a FabricPath topology

C. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4095

D. You do not have to manually assign a switch ID unless you are running a virtual port channel plus (vPC+) because the system assigns a switch ID for you when you enable
FabricPath

A. Zoning must be administered from the primary SAN switch in the fabric.

B. Devices can only belong to one zone.

C. A zone can only be a member one zone set.

D. Zoning is enforced by examining the destination ID field.

E. Only one zone set can be activated at any time.

F. Zone configuration changes are nondisruptive.

A. If you belong to multiple roles, you can execute only the commands that are permitted by both roles (logical AND).

B. On a Cisco Nexus 7000 Series Switch, roles are shared between VDCs.

C. Access to a command takes priority over being denied access to a command.

D. The predefined roles can only be changed by the network administrator (superuser).

E. The default SAN administrator role restricts configuration to Fibre Channel interfaces.

A. It specifies the time delay for a transitioned value to be propagated throughout the network

B. The allocate-delay is the time delay for a new resource to be propagated throughout the network

C. The allocate-delay is the time for FP to go into forwarding state

D. It specifies the time delay for a link bringup to detect conflicts

A. default

B. management

C. system

D. The user must dedicate a VRF for keepalives.