最新的Cisco Implementing cisco ip routing - 642-902免費考試真題

You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that
172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router
172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem?

正確答案: D
說明:(僅 Fast2test 成員可見)
Study the exhibit carefully.

Router R1 is connected to networks 172.16.1.0 /26 and 172.16.1.64 /27. Based on the partial output in the exhibit, which description is correct?

正確答案: C
說明:(僅 Fast2test 成員可見)
When implementing a 6to4 tunnel, which IPv6 address is the correct translation of the IPv4 address 192.168.99.1?

正確答案: C
說明:(僅 Fast2test 成員可見)
After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?

正確答案: C
說明:(僅 Fast2test 成員可見)
A network administrator is troubleshooting a redistribution of RIP routes into OSPF. Given the exhibited configuration commands, which statement is true?

正確答案: E
說明:(僅 Fast2test 成員可見)
Refer to the exhibit.

When you examine the routing tables of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing table. You are also not able to see the R4 Ethernet subnet on the R1 routing table.
Which two configuration changes should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configuration command(s). Choose two answers. (Choose two.)

正確答案: C,D
說明:(僅 Fast2test 成員可見)
Refer to the exhibit.

Which two statements are true about the partial configuration that is provided? (Choose two.)

正確答案: C,E
說明:(僅 Fast2test 成員可見)
When policy-based routing (PBR) is being configured, Which three criteria can the set command specify? (Choose three.)

正確答案: B,E,F
說明:(僅 Fast2test 成員可見)
Refer to the exhibit.

ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network.
If the variance value is configured as 2 on all routers and all other metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths?

正確答案: A
說明:(僅 Fast2test 成員可見)
Which three statements are true about EIGRP operation? (Choose three.)

正確答案: A,B,D
說明:(僅 Fast2test 成員可見)
Refer to the exhibit. The network administrator is trying to configure mutual redistribution between EIGRP and OSPF. Autosummarization in EIGRP 100 AS is disabled. After adding OSPF configuration to router B1, the network administrator checked the routing table of router B2, but none of the EIGRP routes appeared there.
To redistribute the EIGRP AS 100 routes into OSPF, which command should be added, or edited, on router B1 under router ospf 10?

正確答案: D
說明:(僅 Fast2test 成員可見)
How is network layer addressing accomplished in the OSI protocol suite?

正確答案: B
說明:(僅 Fast2test 成員可見)
Which two statements are EIGRP characteristics? (Choose two.)

正確答案: B,D
說明:(僅 Fast2test 成員可見)
Refer to the exhibit.

AS 65500 is running OSPF as its IGP and has two eBGP connections to the Internet provider AS 65501. The provider requires that you advertise all of the prefixes in AS 65500 to the provider as a single 192.168.12.0/22 route. Currently only Routers A and B are able to reach the Internet. Which of the following additions to the configuration will solve this issue?

正確答案: A
說明:(僅 Fast2test 成員可見)
Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6-only and IPv4-only nodes?

正確答案: C
說明:(僅 Fast2test 成員可見)

聯系我們

如果您有任何問題,請留下您的電子郵件地址,我們將在12小時內回复電子郵件給您。

我們的工作時間:( GMT 0:00-15:00 )
週一至週六

技術支持: 立即聯繫 

English 日本語 Deutsch 한국어