最新的Avaya 6101-1免費考試真題

問題1

Consider the following deployment requirements
Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable
Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber.
Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?

A. Two 8348GTx-PWF One 8308XX One 8393SF

B. One 8348GTx One 8348Tx-PWF One 8308 XL One 8393SF

C. Two 8348TX-PWR One 8393SF

D. One 8348GTx One 8348Tx-PWR One 8393SF

正確答案: D

問題2

The Ethernet routing switch (ERS) 5000 switches are being upgraded and it appears that a license is not recognized on the switch.
Which two statements are valid sources of information that will help resolve the license installation? (Choose two.)

A. Use the show license command to get the license installation status

B. Check to see if the MAC address is correct in the license file.

C. Check for an 'invalid license fife' log report

D. Use the show license file command to get the license installation status.

E. Check the record of MSG address changes

正確答案: A,B

問題3

A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches.
Which statement about the correct uplink configuration is true?

A. Use unique MLT IDS for each stack of edge ERS 5500 switches

B. Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.

C. Disable auto negotiation and replace it with VLACP to identify single fiber fault failure

D. Distribute uplinks across different ERS 5500 switches in the stack.

正確答案: D

問題4

Winch CU command is used to validate that synchronization for High Availability mode is correct?

A. show ha-state

B. show ha

C. show ha-all

D. show ha-sync

正確答案: C

問題5

An Ethernet Routing Switch (ERS) 8600 for Virtual Router Redundancy Protocol (VRRP) is being configured. Which CU command would cause this switch to be the VRRP master?

A. ERS860Q:5# config vlan 100 ip vrrp 100 master

B. ERS8600:5# config vlan 100 ip vrrp 100 priority 250

C. ERS8600:5# config vlan 100 ip vrrp 100 priority master

D. ERS8600:5ff config vlan l00 ip vrrp 100 priority 1

正確答案: B

問題6

What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?

A. 16

B. 24

C. 48

D. 50

正確答案: C

問題7

A split multi link trunking (SMLT) for switch clustering is being configured.
Which statement is a configuration requirement for the SMLT?

A. VLANs that are defied on the SMLT are also defined on the MLT that defines the core IST

B. Alternate the primary path of the SMLT connection to load balance the switch core

C. Neighboring edge switch stacks should be connected to each other via DMLT connection to add resilient paths in the event of an SMLT failure

D. CP-limit is configured on edge switch stacks

正確答案: A

最新的Avaya Ethernet Routing Switch Implementation - 6101-1免費考試真題

聯系我們

站內鏈接

最新更新