最新的Cisco 600-601免費考試真題

問題1

What is the leading cause of fiber-optic link failure?

A. crushed fiber

B. poor testing practices

C. contaminants

D. bad connectors

正確答案: C

問題2

What are two benefits that are provided by proper grounding and bonding systems? (Choose two.)

A. equipotential termination points for equipment and cable shields

B. higher speed communications

C. lowest carbon footprint

D. lower equipment power consumption

E. safe discharge of electrostatic energy

正確答案: A,E

問題3

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

A. Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.

B. EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.

C. IEEE1588 and PTP are important for ensuring real-time synchronization.

D. EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.

E. CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.

F. The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.

正確答案: B,C,F

問題4

With what are APC connectors used?

A. copper network cables in corrosive environments

B. high-density copper patch panels

C. Category 6a cables that need tight radius bends

D. single-mode fiber-optic cables to reduce return loss

正確答案: D

問題5

Which characteristic causes multimode fiber-optic cable to differ from single mode?

A. by allowing multiple network services in the same cable

B. use outdoors as well as indoors

C. a wider variety of available connector types

D. shorter maximum network segment length for a given bandwidth

正確答案: D

問題6

Exhibit:

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B.
Which address is the default gateway of Host 3?

A. the address of the router interface Fa0/1

B. the address of the switch interface that is connected to router interface Fa0/0

C. the address of the host that is connected to Network A

D. the address of the host that is connected to Network B

E. the address of the router interface Fa0/0

F. the address of the switch interface that is connected to router interface Fa0/1

正確答案: E

問題7

A network administrator has subnetted the 172.16.0.0 network using a subnet mask of 255.255.255.192. A duplicate IP address of 172.16.2.120 has accidentally been configured on a workstation in the network. The technician on the plant floor must assign this workstation a new IP address within that same subnetwork. Which address should be assigned to the workstation?

A. 172.16.2.127

B. 172.16.1.80

C. 172.16.2.64

D. 172.16.1.64

E. 172.16.2.80

F. 172.16.2.128

正確答案: E

最新的Cisco Managing Industrial Networks with Cisco Networking Technologies - 600-601免費考試真題

聯系我們

站內鏈接

最新更新