最新的Cisco 500-601免費考試真題

問題1

Which three AVS switching modes are supported on Cisco ACI? (Choose three)

A. VLAN, local switching

B. VLAN, no local switching

C. VXLAN, no local switching

D. VXLAN, local switch

E. VPC-HM

F. MAC pinning

正確答案: A,B,C

問題2

Which command is used to successfully SSH into a Cisco ARC or switch CLI using a remote authentication server?

A. ssh apic#rad_check\\[email protected]

B. ssh apic#ad_check//[email protected]

C. ssh apic@rad_check\\[email protected]

D. apic#rad_check//[email protected]

正確答案: B

問題3

Where does the subnet address of the distributed gateway need to be configured when route leaking is required?

A. in the endpoint bridge domain

B. under the contract provider EPG

C. in a shared bridge domain in the tenant common

D. under the contract consumer EPG

正確答案: A

問題4

Which statement about the default MAC address for the distributed gateway in the Cisco ACI Fabric is true?

A. A custom MAC address must be configured under each bridge domain.

B. The default MAC address is 00 11;BD:F9:88:0C.

C. The default MAC address is 00:22:BD:F8:19:FF.

D. There is no default MAC address.

正確答案: A

問題5

Which two statements about tenant bridge domain Layer 2 unknown unicast forwarding modes are true'?
(Choose two.)

A. If forwarding mode is proxy, unknown Layer 2 unicast packets are sent to border leaf proxy for forwarding.

B. If border leaf proxy cannot resolve the destination, packet is flooded.

C. If forwarding mode is flood, unknown Layer 2 unicast is sent to all Layer 2 ports in the bridge domain.

D. Layer 2 unknown unicast can be set to flood or proxy, the default is flood.

E. By default, multicast traffic is always flooded within the bridge domain VLAN.

正確答案: A,C

最新的Cisco Application Centric Infrastructure Support Representative - 500-601免費考試真題