最新的Cisco CCIE Data Center Written - 350-080免費考試真題

A. authorization

B. accounting

C. network monitoring

D. authentication

E. network planning

A. A is an fabric port, B is a downlink port, C is an uplink port, D is a server port, E is a VIC interface, and F is a vNIC

B. A is an uplink port, B is a fabric port, C is a server port, D is a backplane port, E is a DCE interface, and F is a vNIC

C. A is an uplink port, B is a server port, C is a fabric port, D is a backplane port, E is a DCE interface, and F is a vNIC

D. A is an uplink port, B is a fabric port, C is a backplane port, D is a server port, E is a DCE interface, and F is a vNIC

E. A is an uplink port, B is a server port, C is a fabric port, D is a DCE interface, E is a backplane port, and F is a vNIC

A. The storage array must be licensed for iSCSI boot.

B. Boot parameters must be configured in the global group policy.

C. IP subnet of iSCSI initiator has to be in the same subnet as that of storage array.

D. Zoning must be configured.

E. The operating system must be iBFT-compatible.

A. extended unique identifier

B. network qualified name

C. network address authority

D. iSCSI qualified name

E. extended qualified name

F. iSCSI unique identifier

A. If you are on a console connection, the outputs are shown after the event occurs.

B. The command does not have an effect unless you configure "debug enable".

C. The outputs of the debug are redirected on file test on the "log." directory.

D. The outputs of the debug are redirected to the logging buffer.

A. The host will not connect. The vFC port number does not match the Ethernet interface.

B. The host will negotiate using DCBX and will change parameters as required, but a shut/no shut is needed on the interface.

C. The switch will not initialize because it is in the wrong mode.

D. The host will negotiate using DCBX and connect properly.

A. management, Layer 2, and Layer 3

B. control, management, and packet

C. management, packet, and VSM

D. Layer 2, Layer 3, and keepalive

A. 250

B. 500

C. 166

D. 1000

E. 125

A. Ethernet Switching mode must be end-host mode.

B. Default VLAN 1 can be configured explicitly on an Uplink Ethernet Port or Port Channel

C. Symmetrical configuration is recommended for high availability.

D. Each vNIC can communicate with all the disjoint Layer 2 networks.

E. Overlapping vlans are supported.

F. Appliance port cannot be configured with the same VLAN as Uplink Ethernet Port or Port Channel.

A. The switch that connects to the hosts is identified in the design as an NPV edge switch, and the port that connects to the core is an NP port.

B. The interface that is connected to the NPV core will become an FP port.

C. The interface that is connected to the NPV switch will need to be configured as an N-Port.

D. The link between the NPV core switch and edge will come up as an E port.