最新的Cisco Implementing Cisco Wireless Network Fundamentals - 200-355免費考試真題
An engineer has been asked to upgrade the code on a WLC that is running Cisco AireOS 8.0. which two protocols can be used to download the code file to the controller? (choose two)
正確答案: B,E
Which technique divides a 20-MHz channel into 52 sub channels to transmit wireless data?
正確答案: B
說明：（僅 Fast2test 成員可見）
Drag and drop the Cisco CleanAir term from the left onto its correct definition on the right. Not all options are used.
正確答案:
On which tab in a WLC is the RADIUS server configured
正確答案: D
Which antenna type has a gain of 20 to 30 dBI and often is used to interconnect buildings?
正確答案: B
You use 802.1x when configuring layer 2 security in a WLAN. Which type of data encryption do you use?
正確答案: C
Which two characteristics are components of mobility anchoring? (choose two)
正確答案: B,E
An engineer removed an antenna that was providing 3 db of gain and replaced it with one that provides 16db of gain. How has the power level changed?
正確答案: B
The cisco WLC administrator needs the guest client traffic to be sent via a tunnel to a specified controller in the DMZ, no matter which AP the guest user is connected to. What must be configured for a WLAN to achieve this requirement?
正確答案: A
While undergoing a security audit, a network administrator is told to setup the WLANs with at least 128 bit encryption but also keeping the 802.11n speeds. What WLAN configuration would meet the requirements?
正確答案: D
Refer to the exhibit. Which type of roaming is shown, assuming that WLC1 and WLC2 belong to the same mobility group?
正確答案: C
Which command is used to upgrade the operational code when upgrading a cisco ios-xe wlc?
正確答案: D
Microsoft Active directory integrated machines are not authenticating to the internal WLAN. The WLAN settings are WPA2-AES-802.fx and are authenticating to a cisco identity services engine server. You investigate and note that non-domain authenticated machines are properly authenticating to the WLAN using their Active Directory credentials. Why would this problem occur?
正確答案: C
A controller is connected to a cisco catalyst switch. The switch port configuration looks like this:
Interface GigabitEthernet 1/0/20 Switchport
Switchport trunk encapsulatiom dot1q Switchport truck allowed vlan 1,20,30,50 Switchport mode trunk Which controller CLI command assigns its management interface to the native VLAN interface of the CISCO catalyst switch?
Interface GigabitEthernet 1/0/20 Switchport
Switchport trunk encapsulatiom dot1q Switchport truck allowed vlan 1,20,30,50 Switchport mode trunk Which controller CLI command assigns its management interface to the native VLAN interface of the CISCO catalyst switch?
正確答案: D