最新的Cisco Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0) - 200-105免費考試真題

Which channel group mode must you configure on both ports to enable a static EtherChannel?

Which tool or utility can report whether traffic matching specific criteria can reach a specified destination on the ACLs along the path?

Which type of interface can negotiate an IP address for a PPPoE client?

Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?

Drag and Drop Question
Drag and drop the DHCP snooping terms from the left onto the correct descriptions on the right.

A network engineer wants to allow a temporary entry for a remote user with a specific username and password so that the user can access the entire network over the Internet. Which ACL can be used?

Through which three states does a BGP routing process pass when it establishes a peering session with a neighbor? (Choose three.)

Which feature can you use to restrict SNMP queries to a specific OID tree?

Drag and Drop Question
Drag and drop the EIGRP K values from the left onto the correct metric components on the right.

Which three responses does TACAS+ give while querying. (Choose three)

While troubleshooting a GRE tunnel interface issue, show interface command output displays tunnel status up, but line protocol is down. Which reason for this problem is the most likely?

An organization is concerned that too many employees are wasting company time accessing the Internet. Which access list statement would stop World Wide Web access for employees on the range of subnets from 172.16.8.0/24 to 172.16.11.0/24?

You work as a network engineer for SASCOM Network Ltd company. On router HQ, a provider link has been enabled and you must configure an IPv6 default route on HQ and make sure that this route is advertised in IPv6 OSPF process. Also, you must troubleshoot another issue. The router HQ is not forming an IPv6 OSPF neighbor relationship with router BR.
Topology Details
Two routers HQ and BR are connected via serial links.
Router HQ has interface Ethernet0/1 connected to the provider cloud and interface Ethernet 0/0 connected to RA1 Router BR has interface Ethernet 0/0 connected to another router RA2.
IPv6 Routing Details
Ail routers are running IPv6 OSPF routing with process ID number 100 Refer to the topology diagram for information about the OSPF areas The Loopback 0 IPv4 address is the OSPF router ID on each router Configuration requirements
- Configure IPv6 default route on router HQ with default gateway as
2001:DB8:B:B1B2::1.
- Verify by pinging provider test IPv6 address 2001 :DB8:0:1111:1 after configuring default route on HQ.
- Make sure that the default route is advertised in IPv6 OSPF on router HQ This default route should be advertised only when HQ has a default route in its routing table.
- Router HQ is not forming IPv6 OSPF neighbor with BR. You must
troubleshoot and resolve this issue
Special Note: To gain the maximum number of points, you must complete the necessary configurations and fix IPv6 OSPF neighbor issue with router BR IPv6 OSPFv3 must be configured without using address families. Do not change the IPv6 OSPF process ID.

Drag and Drop Question
Drat the Frame Relay acronym on the left to match its definition on the right. (Not all acronyms are used)