最新的Oracle 1z1-400免費考試真題

問題1

You mape a configuration change to a media interface.
Which command must be executed in order to commit the changes to volatile memory?

A. done

B. save-config

C. activate-config

D. commit-config

E. write-config

正確答案: C

問題2

You are enabling management access on a network interface in the Session Border Controller. Which two are applicable?

A. set-hip

B. telnet-port

C. snmp-address

D. add-snmp-ip

E. add-hip-ip

正確答案: B,C

問題3

To replace the Session Border Controller's running configuration with a previous configuration, perform the following:

A. Use display-backups, identify the configuration name and associated number, then issue the run-backup <number> command.

B. Use the restore-backup-config command, followed by save and activate.

C. Use the exec last-known-good-config command.

D. Use the activate-config command.

E. Use the restore-backup-config command.

正確答案: B

問題4

To return the Session Border Controller configuration to a known, factory default state you must___________.

A. Issue the set-system-state offline command.

B. Issue the delete-config command and reboot.

C. Issue the set-system-state offline command and reboot.

D. Press the reset button on the front panel.

E. Issue the delete-config command.

正確答案: B

問題5

Which SIP header does the Session Border Controller check when looking for a match to the "to-address" in the local-policy?

A. Call-ID header

B. Request-URI

C. To header

D. Route header

E. Top most Via header

正確答案: B

說明：（僅 Fast2test 成員可見）

問題6

What two options are available to enable access control in a SIP configuration and how would they be configured?

A. Configure a steering-pool with a smaller subnet than the realm-prefix.

B. Configure the access-control parameter to realm-prefix.

C. Configure the al low-anonymous parameter under the sip-port to agents-only, then configure your SIP peers as session agents.

D. Configure the allow-anonymous parameter to source-realm.

E. Configure the al low-anonymous parameter under the sip-port to realm-prefix and configure an ingress realm addr-prefix to an address that is not 0.0.0.0.

正確答案: B,C

問題7

When SNMP access is enabled to the Session Border Controller, which statement is TRUE?

A. There are no default community strings.

B. The default community strings are acme and packet.

C. Community strings are in passive mode.

D. Only one trap receiver can be configured.

E. The default community strings are public and private.

正確答案: B

問題8

You are logged into the Session Border Controller as superuser.You want to remove other users from the system.
What telnet command is available to remove other users?

A. Remove user <username>

B. Remove user <index number>

C. Kill <index number>

D. Remove users

E. Kill <task-id>

正確答案: B

最新的Oracle Communications Session Border Controller Implementation Essentials - 1z1-400免費考試真題

聯系我們

站內鏈接

最新更新