最新的Hitachi Vantara Qualified Professional - VSP 5000 Series Installation - HQT-4160免費考試真題

A. SBX

B. UBX

C. DBS2

D. FBX

A. Using the "Set IP Address" on the SVP GUI.

B. The Hitachi Distribution Centers pre-configure the same IP address on all new machines.

C. It must be set up by the customer's network administrator.

D. It is generated by the SSVP.

A. Customer Engineers (CEs) should always perform the "New Installation" procedure when a new unit arrives at customer site.

B. You can perform the "New Installation" procedure if a newly installed system does not power on and the Hitachi Vantara Technical Support instructs you to do so.

C. Hitachi Vantara recommends not to perform the "New Installation" procedure on second-hand systems.

D. A customer can make a request to Hitachi Vantara Technical Support for a "New Installation" procedure, if they want to reinitialize a system entirely so all former data will be erased.

A. 60

B. 24

C. 12

D. 48

A. ISWs are switches that route data between nodes using Hitachi Interconnect Edge and X-Path cables, and they are located on the Hitachi Service and Network Boxes (HSNBXs).

B. ISWs are switches that route data between nodes and they are located on each controller of the node.

C. ISWs are switches that provide redundancy for data path and they are only used when the number of CBX pairs is higher than two.

D. ISWs are standalone, optional switches than can be used for both network and data path.

A. Setting BIOS passwords

B. Installing surveillance cameras in the data center

C. Configuring firewall settings

D. Securing the racks to the floor