最新的EMC DEE-1721免費考試真題

問題1

You need to configure a server that is connected to a Storage Center through iSCSI. You will need to use one or more hardware iSCSI host bus adapters. In addition, if connectivity is lost due to controller failover, the server needs to reconnect to the Storage Center iSCSI target ports.

A. Delayed ACK

B. Spin Up Delay

C. MAC Spoofing

D. ARP Redirect

正確答案: D

問題2

You need to upgrade the memory form 16 GB to 64 GB in an existing dual controller SC8000. The system has been verified and failover has been tested. What is the correct sequence of workflow tasks that need to occur?

正確答案:

問題3

When configure ports in the Setup wizard, which purposes can be set on a port in Virtual Port Mode?

A. Front-end, Front-end Reserved, and Front-end Primary

B. Front-end, Front-end Reserved, and Back-end

C. Back-end, Unknown, and Front-end

D. Back-end, Unknown, and Front-end Primary

正確答案: C

問題4

You map a volume to a Microsoft Windows 2012 R2 server and scan for disks within the Windows Disk Management Console. You are able to see multiple Instances of the mapped volume. In addition, the operating system was recently installed on the server that is experiencing the issue. No additional features have been added.
Which action should occur within Windows to correct the issue?

A. Select the disk object with the lowest disk number and delete the rest Add the "Multipath I/O" server feature Reboot the server after making the correct configuration changes Verify the iSCSI Initiator service runs on the server

B. Add the Storage Center specific harware ID within Windows MPIO
Select the disk object with the lowest number and delete the rest
Verify the iSCSI Initiator service runs on the server

C. Add the Storage Center specific harware ID within Windows MPIO
Add the "Multipath I/O" server feature
Reboot the server after making the correct configuration changes

正確答案: C

問題5

Based on best practices, an SC Series storage array, network, and servers have been successfully installed and configured. The impact of failing various devices and connections must be tested to validate that there is no single point of failure in the environment.
The environment consists of the following:

What are the available environment redundancy tests that can be performed?

A. Restart one controller, remove power from one of the switches, and remove one power cable from each device

B. Remove power from one of the switches, disconnect both server iSCSI interfaces, and remove all iSCSI

C. Remove all SAS cables form one controller, disconnect both server iSCSI interfaces, and remove all iSCSI cables form one controller

D. Restart one controller, remove all SAS cables form one controller, and remove one power cable from each device

正確答案: C

問題6

A dual controller SC Series using iSCSI needs to be installed. The site will use two switches/VLANs and run in Virtual Port mode. Which exhibit represents the correct iSCSI cabling?
A)

B)

C)

D)

A. Option D

B. Option B

C. Option C

D. Option A

正確答案: A

問題7

During the deployment of an SC Series storage array, the redundancy of a tier may be restricted dual redundancy. What is the cause for this behavior?

A. Depending on the drive firmware level and drive sire, Dell Storage Manager will enforce dual redundancy

B. Depending on the number of spares configured on the system and SCOS version, dual redundancy may be enforced

C. Depending on the drive manufacturer and SCOS version, Del Storage Manager will enlace dual redundancy

D. Depending on the drive speed, drive sire, and SCOS version, dual redundancy may be enforced

正確答案: A

最新的EMC Expert - SC Series - DEE-1721免費考試真題

聯系我們

站內鏈接

最新更新