最新的Oracle 1z0-404免費考試真題

問題1

Which configuration step is correct for a phy-interface configuration element used for signaling and/or media?

A. A phy-interface configuration element for signaling and/or media hasthe operation-type parameter set to control.

B. After configuring a phy-interface configuration element for signaling and/or media, a reboot of the Session Border Controller is required.

C. A phy-interface elementmust be configured for each interface used for High Availability
(HA) heartbeats, but not for signaling and/or media.

D. A phy-interface configuration element must be configured for each interface used.

E. A unique phy-interface configuration element is created for all signaling/media interfaces.

正確答案: B

問題2

Which three statements are true about the bootloader? (Choose three.)

A. It is a Windriver's VxWork product

B. It is based on Linux

C. It looks at the boot parameters

D. It reads the imagefile

E. It decompresses the image file and loads it into the main RAM

正確答案: C,D,E

問題3

Which two states are needed by the active node while transitioning to standby? (Choose two.)

A. Out of service

B. Becoming-standby

C. Relinquishing-active

D. Becoming-active

E. Relinquishing-standby

正確答案: C,D

問題4

Which two statements are true about realm bridging in the Session Border Controller?
(Choose two.)

A. You can only configure a single SIP port per realm.

B. The ingress realm and egress realm for a specific SIP session can be the same.

C. You can configure more than one SIP port per realm.

D. The ingress realm is always different than the egress realm for a specific SIP session.

E. Therealm-config configuration element provides G.711 to G.729 transcoding functions.

正確答案: B,C

問題5

You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media.
Identify two valid configuration steps for supporting VLAN 12 (Choose two.)

A. Navigate to the phy-interface configuration element and configure the hip-id parameter.

B. Navigate to the network-interface configuration element and configure the name parameter.

C. Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

D. Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

E. Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

正確答案: A,D

問題6

A steering pool defines _____________.

A. an IP address and range of ports the Session Border Controller will use to declare itself as the destination for media flows in a session

B. a range of ports used to route media flows as they egress the Session Border Controller

C. a range of IP addresses and a pool of ports the Session Border Controller will use to declare itself as the destination for all subsequent media flows in a dialog

D. an IP address and port the Session Border Controller uses for steering media to the external media server

E. arange of IP addresses used to route media flows as they egress the Session Border
Controller

正確答案: A

問題7

You are associating network-interface configuration elements with a physical- interfaceconfiguration element on the Session Border Controller.
Which parameter must contain the same unique ID in these two configuration elements?

A. name

B. unique-id

C. port-id

D. sub-port-id

E. identifier

正確答案: C

最新的Oracle Communications Session Border Controller 7 Basic Implementation Essentials - 1z0-404免費考試真題

聯系我們

站內鏈接

最新更新